Simonton Door Installation Nationwide | TruePane Windows & Doors

Simonton Door Installation: The Delray Beach Owner’s Guide

Simonton door installation in Delray Beach typically runs $380 to $900 installed when you’re replacing rollers, hinges, or a complete threshold assembly on an existing slab. We stock the common Simonton-compatible hardware on our trucks, so most Delray Beach callers get the swap done in one visit. The way owners usually find us is simple: a patio door that scrapes the track when it’s humid, a handle that spins without catching, or a panel that lets rain blow in during the August storms we get every year.

Call (561) 940-2917

Which Simonton Models This Applies To

This guidance covers the Simonton sliding patio doors and hinged terrace doors still common in Delray Beach homes built from the late 1990s through the mid-2010s. That includes the Reflections 5500 and 5050 series sliders, the StormBreaker Plus impact-rated line, and the older ProFinish patio doors you’ll still find in the older neighborhoods off Linton Boulevard and along the barrier island. If you’ve got a hinged Simonton entry door, the relevant hardware is usually a swept threshold, a multi-point lock body, or adjustable hinges.

The compatibility gotcha with Simonton is this: the roller housing changed dimensions between the pre-2012 and post-2012 production runs. A roller cart that fits a 2009 Reflections door will not seat in a 2015 unit, and the difference is about 3/16 of an inch in the housing width. We measure the old roller before we ever pull a replacement off the truck. On the OEM question: Simonton-branded rollers and lock assemblies are good hardware, but we also carry a machined stainless aftermarket roller set that outlasts the factory nylon wheel by a wide margin in Delray Beach’s salt air. We’ll quote both on paper side by side and let you see the price difference before we touch the door.

Signs Your Simonton Door Installation Is Failing

Most Delray Beach owners don’t discover a failing door part until it’s been failing for months. Here’s what we see on service calls:

• The door scrapes or binds near the latch side, worse in summer. The top roller has flattened or the frame has settled, and the slab is dragging on the threshold. In Delray Beach’s wet summers, the wood framing behind the track swells and narrows the clearance.
• The handle turns but the latches don’t retract. The multi-point gearbox inside the handle has stripped. This is a Simonton-specific failure mode we see often; the gearbox is zinc, and after about a decade of Florida humidity and salt air, the teeth round off.
• Rain or daylight shows under the closed panel. The threshold cap or the weatherstrip has failed. On Simonton sliders, the threshold’s vinyl cap splits along the screw channel, and once it’s cracked, water follows the screws into the subfloor.
• The panel rocks when you push on it. One roller has collapsed or seized. Sliding a door on one good roller and one frozen one wears the track unevenly, and eventually the track itself needs to be replaced.
• The door is hard to open after rain. The rollers are corroded or the track is packed with sediment and scale. This is a Florida-specific problem: our rain carries fine sand and salt, and that grit works its way into the roller bearings and grinds them down.

Replacement Cost & What’s Included

Installed pricing on Simonton door hardware in Delray Beach breaks down like this:

• Roller replacement, both panels: $180 to $340. Includes pulling the panels, cleaning the track, replacing all four roller carts, and re-setting the panel height so the latch lines up.
• Multi-point lock or handle replacement: $220 to $420. Includes the new Simonton-compatible lock body or gearbox, strike adjustment, and test-latching in front of you.
• Threshold and weatherstripping replacement: $260 to $520. Includes the new threshold cap or full threshold assembly, sealant, and re-anchoring the track.
• Complete door frame or slab service: $500 to $900 when the track is worn through or the frame has rot at the corners. We quote this only after opening the area and seeing the framing.

Every quote is a written line-item price before work starts. No change orders, no surprise line items. Every install is covered by our Done Right Promise: if the part or the work fails in the first 90 days, we fix it without a paperwork fight.

DIY or Call Us?

You can safely do the diagnosis on your own: check whether the panel is dragging on the threshold, look at the roller wheels with a flashlight, try the handle and see if the latches move. That tells you what’s wrong, and it helps you describe the problem accurately when you call. What you should not do is pull a Simonton slider panel out of its track without a second pair of hands and a flat pry bar. These panels run 80 to 120 pounds, and when a homeowner drops one, it folds the track and turns a $200 roller job into a $700 track replacement. We’re glad to walk you through the phone diagnosis, and if you decide not to touch it yourself, a technician will be out to handle it. Call (561) 940-2917.

FAQs