Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Mr-Glass Roof Repair in Delray Beach: What to Know First
We provide independent Mr-Glass roof repair in Delray Beach, diagnosing and fixing skylights, roof glass panels, and glazing failures on Mr-Glass installations throughout Palm Beach County. Most Mr-Glass roof repairs run between $425 and $1,850 depending on the panel size, seal condition, and whether we’re replacing glass or the surrounding frame components. We’re not affiliated with or authorized by Mr-Glass, but as an independent Mr-Glass service provider, we’ve been called out to enough of their installations to know exactly where they fail in this climate. Turnaround on a typical single-panel repair is two to five business days once we’ve measured and ordered the glass. Call (561) 940-2917 and a live person will answer; we’ll ask a few questions about your Mr-Glass unit and schedule a site visit.
Key Takeaways
- We repair Mr-Glass skylights, roof panels, and glazing in Delray Beach as an independent service provider; we are not a Mr-Glass authorized dealer.
- Most Mr-Glass roof work runs $425 to $1,850; an exact quote always comes as a written line-item estimate, never a verbal range.
- The biggest Mr-Glass rooftop failures we see in Delray Beach are edge-seal breakdowns from wind-driven rain and frame gasket shrinkage from salt air and UV exposure.
- Every job carries our Done Right Promise, with a written workmanship guarantee, no fine print, no arguments.
- Call (561) 940-2917 for a free estimate; a live person answers, 24/7.
How Mr-Glass Products Fail - and How We Fix Them
Mr-Glass sells through a network of Florida dealers and has been spec’d into a fair number of Delray Beach homes over the last fifteen to twenty years. Their roof assemblies come in a few configurations - fixed curb-mount skylights, flat glass panels, and sloped glazing systems, most running tempered or laminated glazing in extruded aluminum or vinyl frames. The parts themselves are generally fine; it’s the installation details and the Florida climate that tend to undo them. Here’s what we see in the field.
- Mr-Glass curb-mount skylight gasket shrinkage (Classic and Deluxe fixed units). The foam-compression gasket between the glass and the aluminum curb dries out and loses memory after six to ten years in Delray Beach sun. Once it pulls back, wind-driven rain works its way under the perimeter. The first sign is drips at the inside flange of the ceiling trim, not pooling on the floor. The fix is a full gasket replacement with a compression-grade EPDM, not a caulk smear.
- Seal failures on Mr-Glass double-glazed sloped panels. When the edge seal on a sloped Mr-Glass insulated unit gives out, condensation appears between the panes - and on a roof assembly, it collects and refills every time the panel heats. We see this most often on Mr-Glass venting skylights where the gasket channel facing the morning sun bakes first. If the frame is sound, we replace the insulated glass unit, not the whole curb.
- Aluminum frame seam leaks at the mitered corners. Mr-Glass’s box-frame curb corners are mitered and bonded with interior sealant. Over time, the thermal expansion and contraction of the aluminum in our afternoon thunderstorm cycles pops the seam. Water tracks along the inside of the frame, then shows up at the lowest corner. We disassemble, clean, and re-bond the corner with structural sealant, then test the full perimeter.
- Flashing failures on curb-mount installations. A Mr-Glass skylight installed flush on a low-slope Delray Beach roof is only as dry as the metal flashing around the curb. Once a roofer’s nails back out or a step flashing lifts, the Mr-Glass unit gets blamed for water that was never its fault. We remove the trim, inspect and replace the flashing as needed, and reset the curb so the glass has a clean, waterproof seat.
- Operational failures on Mr-Glass venting units. Mr-Glass electric venting skylights use a motor-drive arm to open and close the glass. After years of salt air and humidity at the coast, the drive-motor gear strips, and the owner gets a half-open skylight that won’t budge on a 94-degree afternoon. We stock and order replacement drive assemblies and repair mechanical arms, and always test the open-close cycle five times before we call it done.
Our Mr-Glass Roof Repair Process
When a Mr-Glass roof unit is leaking or fogged, the difference between a one-time fix and a second call in six months is the diagnostic work that happens before anyone touches a pane. Here’s how a typical Mr-Glass roof repair runs with us.
- 1
Site visit and water trace. We schedule a specific arrival window, show up in uniform, and start with a visual inspection of the glass, the gasket channel, the curb corners, and the surrounding roof flashing. We trace the water path - not just the spot where it drips - and photograph everything with time stamps.
- 2
Failure confirmation. If the unit is insulated glass, we check the seal under natural light for condensation or haze. On double-glazed Mr-Glass panels, the interior fog pattern tells us whether it’s a true seal failure or just humidity cycling. We never guess here.
- 3
Parts decision: OEM vs. aftermarket. Mr-Glass does not sell directly to the public, so owners get whatever their original dealer still carries. We source OEM where available and tell the homeowner the lead time; where OEM is no longer made, we use a matching aftermarket gasket, glass, or drive assembly and say so, in writing, before we install it.
- 4
Written line-item estimate. We hand you a paper quote that lists the part, the part number where applicable, the labor, and the warranty duration for each item. No verbal ranges, no “we’ll see what we find” pricing.
- 5
Repair and cleanup. We remove the old glass or component, prep the frame, set the new work, and re-seal the perimeter with materials rated for our climate. We clean the work area, remove all old glazing and hardware, and leave no debris on the roof.
- 6
Water test and warranty registration. We run a controlled water test along the perimeter and wait the required setting time before confirming the seal. Then we register both manufacturer warranty layers in writing and leave you a copy before the truck leaves the driveway.
What Mr-Glass Roof Repair Costs in Delray Beach
Roof repair on a Mr-Glass unit is priced by the glass size, the failure, and the access difficulty. Most jobs we do in Delray Beach land between $425 and $1,850, with the biggest variable being whether we’re replacing a gasket and re-sealing, or pulling and replacing an entire insulated glass panel.
Common Mr-Glass roof repair scenarios in Delray Beach:
- Gasket replacement on a single fixed curb-mount unit: $425 to $680
- Insulated glass replacement on a standard fixed skylight: $780 to $1,250
- Motor drive replacement on a venting unit: $510 to $880
- Flashing repair and curb re-set: $650 to $1,200 (depends on the existing roofing)
- Full skylight replacement with curb work: $1,600 to $2,800
If the leak is in the flashing, we’ll tell you, and we’ll show you the pictures. If a Mr-Glass unit is twenty years old with a dead seal and a corroded frame, we’ll give you the replacement number too. Every estimate is free, written, and good for 30 days. Call (561) 940-2917 to schedule a site visit in Delray Beach.
Why Delray Beach Homeowners Call TruePane Windows & Doors for Mr-Glass Work
We’ve served Delray Beach and the surrounding areas since 2008, and our founder Dale Kessler grew up in Lake Ida. This is not a franchise playbook. We hire local, we train apprentices into journeymen, and we act like a company that plans to be in town in thirty years. On a Mr-Glass roof repair, that means we show up when we say, we measure every opening twice, and we hand you the warranty paperwork before the truck leaves. Every job is covered by our Done Right Promise and The Keystone Standard: both manufacturer warranty layers registered in writing, durations stated, no arguing. We work on Mr-Glass, but we also carry and install PGT, CGI, CWS, and ES Windows, so if the right call turns out to be a replacement, we can quote you side by side on paper and let you see the difference. Call (561) 940-2917. A live person answers, day or night.
FAQs
Can TruePane repair a Mr-Glass skylight even though you’re not an authorized Mr-Glass dealer?
Yes. We repair Mr-Glass roof glazing and skylights as an independent Mr-Glass service provider, which means we can diagnose and fix the unit without being bound to a single manufacturer’s parts channel. We use OEM parts when available and quality aftermarket parts when OEM has been discontinued, always stated in writing. Call (561) 940-2917 to discuss your Mr-Glass unit.
Will working on my Mr-Glass skylight void the manufacturer warranty?
If your Mr-Glass installation is still under the original manufacturer warranty, we’ll review the warranty language with you before any work starts and tell you, in writing, which repairs may affect that coverage. In many cases, a gasket or flashing repair sits outside the Mr-Glass warranty anyway, and a new seal does not void the glass warranty. Call (561) 940-2917 if you want a straight answer before the work begins.
How fast can you repair a leaking Mr-Glass skylight in Delray Beach?
For a typical single-panel gasket or reglazing repair, most Delray Beach jobs are completed within two to five business days once we’ve measured and ordered materials. Some in-stock gaskets and drives can be done same week. We’ll give you a written timeline on the estimate, not a vague promise. Call (561) 940-2917 to schedule a site visit.
Should I repair or replace my Mr-Glass skylight?
If the frame is structurally sound and the glass is intact, repair is almost always the lower-cost option. If the frame is corroded, the curb is rotted, or the insulated unit is fogged and the skylight is over eighteen years old, replacement starts making more sense. We’ll show you both numbers on paper and let you decide. Call (561) 940-2917 for a free estimate.
Do you offer any discounts on Mr-Glass roof repair?
We offer Free Written Repair Estimates, a maintenance check, and a permanent 5% discount for seniors and veterans. These apply to Mr-Glass roof repair work as well as any other window or door service we perform. Call (561) 940-2917 and mention the discount when you schedule.
Contact TruePane Windows & Doors for Mr-Glass Roof Repair in Delray Beach
If your Mr-Glass skylight is leaking, fogged, or simply not opening the way it should, call (561) 940-2917 for a free estimate. A live person answers, 24 hours a day, 7 days a week. We’ll schedule a site visit in Delray Beach, diagnose the failure, and put the price and the warranty in writing before any work begins. If it is not in writing, it is not a guarantee - it is a conversation.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Delray Beach and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.



Before
After
Before
After
Before
After