Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterMr-Glass Roof Replacement & Installation in Delray Beach: What to Know First
Mr-Glass roof replacement and installation in Delray Beach typically runs between $950 and $3,400 depending on the panel count, frame condition, and whether the existing curb mounts can be reused. Most jobs are completed in one to two days once the glass is on hand, and we quote fixed pricing before any work begins. If you own a Mr-Glass skylight, roof window, or glass roof section that is leaking, clouded, or structurally failing, this page tells you what to expect and what it should cost. Call (561) 940-2917 to schedule a free estimate. We are an independent Mr-Glass service provider in Delray Beach, not a franchise or a manufacturer arm.
This page is written for the homeowner who has lived in the same house for twenty years and is not looking to do this twice. We will tell you what fails, why it fails here in South Florida specifically, and what we do differently so it does not fail again.
How Mr-Glass Products Fail - and How We Fix Them
Mr-Glass roof systems see specific failure patterns in Delray Beach. We have pulled enough of them apart to name the issues by series. Here are the ones we see most often:
- Frame-to-curb seal separation on the SkyVue series. The factory seal between the aluminum curb and the glass frame breaks down after eight to twelve years of direct Florida sun. Water gets in not through the glass, but around it. The fix is removing the unit, cleaning the curb back to clean metal, applying a marine-grade sealant, and re-bedding the frame. Caulking over the outside never holds.
- Condensation between panes on the Horizon dual-glaze line. A failed edge seal lets humid Delray Beach air into the airspace. You get fog you cannot wipe off. The fix is glass replacement, not a new frame, if the frame is still true. We check the frame first. Replacing glass into a warped frame is money wasted in a season or two.
- Hinge fatigue on venting SkyVue roof windows. The factory hinges wear in the salt-and-humidity air near the coast. Homeowners report the window “dropping” on one side or not seating flush. The fix is a full hinge replacement with a heavier aftermarket set, not a lubrication. Lubrication masks it; it does not fix it.
- Stress cracks in the glass on fixed glass roofs with no expansion gap. The concrete or steel framing expands in the summer heat, and if the original install did not leave the right gap, the glass carries the stress. You get cracks that start at one corner and run. This is an installation error, not a glass defect. We correct the framing clearance before the new panel goes in.
- Discontinued curb-mount sizes on older Mr-Glass installations. Homes built in the 1990s and early 2000s around Delray Beach often have curb sizes Mr-Glass no longer stocks. We can fabricate an adapter curb or have a panel cut to the original dimensions, so you are not forced into reframing the roof opening. That saves the roof deck, which is the expensive part.
Our Mr-Glass Roof Replacement & Installation Process
This is how a Mr-Glass job comes together at TruePane Windows & Doors. No mystery, no surprises on the bill.
- 1
Call, measure, and diagnose. You call, a live person answers. We come out at the scheduled time, measure the opening twice, and identify the actual failure. Dale Kessler has been reading frames in this climate for over forty years, and he does not rush the diagnosis.
- 2
Parts decision on paper. We quote OEM and quality aftermarket options side by side with the price of each and the warranty of each, in writing. You see exactly what you are buying and what it is protected by.
- 3
Fixed quote. We give you one number. If we find something once the old unit is out that changes the scope, we stop and talk to you before spending another dollar. No change orders slipped into the final bill.
- 4
Removal and prep. We remove the old glass and frame, inspect the curb or roof opening, and correct any clearance or sealing issues. The new panel goes in true and level.
- 5
Sealing, flashing, and testing. Marine-grade sealant, proper flashing, and a water test before we call the job done. If the pane is not true, the job is not done.
- 6
Warranty registration and cleanup. Both warranty layers are registered in writing before the truck leaves the driveway. We haul away the old materials. You get the paperwork, the warranty dates, and our number to call if anything is off.
What Mr-Glass Roof Replacement & Installation Costs in Delray Beach
Pricing depends on the series, the panel dimensions, and whether the curb and frame can be reused. Here are the ranges we have quoted on Delray Beach homes in the past year:
| Scenario | Typical Cost Range |
|---|---|
| Single fixed SkyVue glass panel, standard curb reuse | $950-$1,400 |
| Horizon dual-glaze glass replacement (frame stays) | $650-$1,100 per panel |
| Venting SkyVue roof window, full hinge replacement | $480-$780 per unit |
| Full glass roof section replacement with new curb adapter | $2,100-$3,400 |
| Structural reframing of the roof opening (if needed) | $600-$1,200 added |
What moves the price: the condition of the curb, whether the roof opening is square, whether the glass requires impact rating, and accessibility. A rooftop that is easy to walk versus one with a steep pitch changes the labor. We give you a written line-item quote before work starts so the number you approve is the number you pay. Call (561) 940-2917 to schedule your free estimate.
Why Delray Beach Homeowners Call TruePane Windows & Doors for Mr-Glass Work
We built this company in Delray Beach, and Dale Kessler grew up in the Lake Ida neighborhood. That matters when you need someone to stand behind a glass roof installed over your living room. Every Mr-Glass job carries the Done Right Promise: if it is not done right, we make it right, no paperwork fight and no fine print. The Keystone Standard means both manufacturer warranty layers are registered in writing before our truck leaves the driveway, with the durations stated. If it is not in writing, it is not a guarantee - it is a conversation.
We are an authorized installer for more than a dozen manufacturer lines, including PGT, CGI, CWS, and ES Windows, so when a Mr-Glass unit is beyond saving, we can show you side by side what a replacement from another line looks like in price and warranty. Our techs are background-checked, uniformed, and trained to work in your home the way they would work in their own mother’s. A live person answers our phone 24 hours a day, every day. Not a voicemail tree. Not a callback form.
FAQs
It depends on whether the frame is true and whether the seal channels are intact. Glass-only replacement works when the frame is square and the hinges are sound. Hinges can be replaced. Curbs can be rebuilt. We recommend replacement when the frame is stress-cracked or corroded past safe anchoring. Call (561) 940-2917 and we will give you an honest answer after looking at the unit, not before.
Not unless we find a structural problem hidden behind the old unit, and we will not spend a dollar on that without calling you first. The quote you approve is the price you pay. Hidden reframing work is the only thing that changes a number, and you would see it before we proceed.
We are an independent service provider, not a Mr-Glass authorized dealer, so some limited manufacturer warranties may require a qualified glazier but not necessarily an authorized one. The parts warranty applies to the parts; our workmanship is covered by our Done Right Promise regardless. We will tell you up front exactly what your warranty covers before any work is scheduled.
Florida building code requires impact-rated opening protection in wind-borne debris areas, and Delray Beach is in one. If your existing Mr-Glass panel is not impact-rated, a replacement must be. We will confirm the code requirement for your specific address and quote accordingly.
Most residential jobs run one to two days once the glass is on hand. Custom panel fabrication can add a week or two. Special-order sizes that have been discontinued take the longest. We keep you updated with real dates, not vague “soon.” Call (561) 940-2917 for a timeline specific to your opening.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Delray Beach and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.